Toyota Sienna Service Manual: Removal
1. REMOVE ROOF DRIP SIDE FINISH MOULDING
- Put protective tape around the roof drip side finish moulding.
- Using a remover for the roof moulding, disengage of the clips both in the front and rear ends of the roof drip side finish moulding and then remove the roof drip side finish moulding.
NOTICE:
- Do not remove the clips.
- If the clips are damaged or removed accidentally, exchange them for supply ones.
Roof drip side finish moulding
COMPONENTS
...
Installation
1. INSTALL ROOF DRIP SIDE FINISH MOULDING
When exchanging the clips
Remove the tape that remains on the mounting
surface of the vehicle body and then clean the
surface with white gasolin ...
Other materials:
Diagnosis system
1. DESCRIPTION
(a) Release the parking brake pedal.
(b) Check the warning lights.
When ignition switch is turned ON, check that the
ABS warning light and brake warning light come on
for 3 seconds.
HINT:
When parking brake is applied or the level of the
brake fluid is low, the bra ...
Installation
1. INSTALL THROTTLE BODY
Install a new throttle body gasket to the intake air
surge tank.
Install the throttle body with the 4 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Connect the 2 water by-pass hoses.
Connect the throttle body connector and clamp.
2. ...
TC and CG Terminal Circuit
DESCRIPTION
DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the
DLC3. The DTCs are indicated
by blinks of the tire pressure warning light.
WIRING DIAGRAM
HINT:
When each warning light blinks continuously, a ground short in the wiring of
terminal TC of the DLC3 or an ...
