Toyota Sienna Service Manual: Removal
1. REMOVE OUTSIDE MOULDING
- Put protective tape around the outside moulding.
- Using a heat light, heat the moulding between 40 to
60 C (104 to 140 F).
NOTICE: Do not heat the moulding excessively.
- Tie both piano wire ends to a wooden block or a similar object.
- Cut off the tape by pulling the piano wire and remove the outside moulding with reference pins remaining on the moulding.
NOTICE:
- If reusing the outside moulding, take care not to damage the outside moulding.
- Do not damage the body.
- Be careful of the reference pins on the outside moulding when removing the outside moulding.
Outside moulding
COMPONENTS
...
Installation
1. INSTALL OUTSIDE MOULDING
Using a heat light, heat the mounting surface of the
vehicle body between 40 to 60 C (104 to 140 F).
NOTICE:
Do not heat the body excessively.
Remove the tape f ...
Other materials:
Installation
1. Install purge vsv
(A) install the purge vsv with the bolt.
Torque: 10 n*m (102 kgf*cm, 7 ft.*Lbf)
(B) connect the 2 vacuum hoses and no. 1 Vacuum
switching valve connector.
2. INSTALL V-BANK COVER SUB-ASSEMBLY (See
page EM-63)
3. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL ...
Trouble in Passenger Airbag ON / OFF Indicator
DESCRIPTION
The occupant classification system detects the front passenger seat
condition. It then informs a
passenger of the front passenger airbag, the front seat side airbag RH and front
seat belt pretensioner
RH condition (activated/not activated) by the passenger airbag ON/OFF indicator. ...
Brake Switch
DTC P0504 Brake Switch "A" / "B" Correlation
DTC P0724 Brake Switch "B" Circuit High
DESCRIPTION
The stop light switch is a duplex system that transmits two signals: STP and
ST1-. These two signals are
used by the ECM to monitor whether or not the brake system is ...
