1. REMOVE REAR DOOR WINDOW FRAME MOULDING
NOTICE: Do not heat the rear door window frame moulding excessively.
NOTICE: If reusing the moulding, take care not to damage the rear door window frame moulding.
2. REMOVE REAR DOOR WINDOW REAR FRAME MOULDING
NOTICE: Do not heat the rear door windou rear frame moulding excessively.
NOTICE: If reusing the moulding, take care not to damage the rear door windou rear frame moulding.
Check component status
(a) Compare the test value with the minimum test limit
(MIN LIMIT) and maximum test limit (MAX LIMIT).
(b) If the test value is between the minimum test limit
and maximum test limit, the component is
functioning normally. If not, the component is
malfunctioning. The test value is usually sign ...
Cannot Call in a Certain Place
INSPECTION PROCEDURE
1 CHECK SURROUNDING CONDITIONS
Check if the cellular phone can make calls in a certain
place.
OK:
It can make calls
2 CHECK RECEPTION
Enter the "Information" screen by pressing the "INFO"
switch.
Select "Telephone".
...
Stuck in Deceleration Sensor
DESCRIPTION
The yaw rate sensor and deceleration sensor signal is sent to the skid
control ECU through the CAN
communication system. When there is a malfunction in the communication, it will
be detected by the
diagnosis function.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
When ...