1. REMOVE BACK DOOR CENTER GARNISH (See page ET-18)
2. REMOVE POWER BACK DOOR ROD (See page ED- 220)
3. REMOVE BACK DOOR LH SIDE GARNISH
4. REMOVE BACK DOOR RH SIDE GARNISH
5. REMOVE BACK DOOR PULL STRAP (See page ED- 221)
6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
7. REMOVE LH BACK-UP LIGHT ASSEMBLY (See page LI-90)
8. REMOVE RH BACK-UP LIGHT ASSEMBLY (See page LI-90)
9. REMOVE BACK DOOR OUTSIDE GARNISH
Improper Aiming of Radar Sensor Beam Axis
DTC P1572 Improper Aiming of Radar Sensor Beam Axis
DESCRIPTION
This DTC is output when the scanning angle of the laser sensor is incorrect.
This DTC is also output when
the laser sensor beam axis is determined to be in an incorrect position.
DTC No.
DTC Detection Condition
...
Removal
HINT:
On the LH side, use the same procedures as on the RH side.
1. REMOVE FRONT DOOR SCUFF PLATE RH
Using a screwdriver, disengage the 3 clips and 2
claws, and remove the scuff plate.
HINT:
Tape the screwdriver tip before use.
2. REMOVE FRONT DOOR SCUFF PLATE LH
3. REMOVE REAR DOO ...
Emission inspection and
maintenance (I/M)
programs
Some states have vehicle emission inspection programs which
include OBD (On Board Diagnostics) checks. The OBD system
monitors the operation of the emission control system.
If the malfunction indicator lamp comes on
The OBD system determines that a problem exists somewhere in the
emission contr ...