1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
(a) Disconnect the sensor connector.
(b) Using SST, remove the sensor from the exhaust manifold.
SST 09224-00010
3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Disconnect the heated oxygen sensor (for Bank 1 Sensor 2) connector under the center console.
(b) Remove the 2 bolts and 2 compression springs.
(c) Remove the 6 nuts and front exhaust pipe assembly.
4. REMOVE EXHAUST MANIFOLD RH
(a) Remove the nut, bolt and exhaust manifold stay.
(b) Disconnect the air fuel ratio sensor (for Bank 1 Sensor 1) connector.
(c) Remove the 6 nuts and exhaust manifold RH.
(d) Remove the gasket and exhaust manifold to head gasket.
5. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
(a) Using SST, remove the sensor.
SST 09224-00010
Check and replace ecu
NOTICE: • The connector should not be disconnected from
the ECU. Perform the inspection from the
backside of the connector on the wire harness
side.
• When no measuring condition is specified,
perform the inspection with the engine stopped
and the ignition switch on.
• Che ...
Disassembly
1. REMOVE CENTER CLUSTER MODULE KNOB NO.1 (for Manual Air Conditioning
System)
(a) Remove the center cluster module knob No. 1.
2. REMOVE CENTER CLUSTER MODULE KNOB NO.2 (for Manual Air Conditioning
System)
(a) Release the 2 claws fittings and remove the center
cluster module knob No ...
Canceling and resuming the constant speed control
Pulling the lever toward you
cancels the constant speed
control.
The speed setting is also canceled
when the brakes are applied.
Pushing the lever up resumes
the constant speed control.
Resuming is available when the
vehicle speed is more than approximately
25 mph (40 km/h). ...