Toyota RAV4 manuals

Toyota Sienna Service Manual: Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ENGINE UNDER COVER NO.1

3. DRAIN AUTOMATIC TRANSAXLE FLUID

(a) Remove the drain plug and gasket, and drain the ATF.

(b) Install a new gasket and the drain plug.

Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)

4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUBASSEMBLY

REMOVE AUTOMATIC TRANSAXLE OIL PAN SUBASSEMBLY

(a) Remove the 18 bolts, oil pan and gasket.

NOTICE: Some fluid will remain in the oil pan. Carefully remove the oil pan so that fluid remaining in the pan does not spill out.

REMOVE AUTOMATIC TRANSAXLE OIL PAN SUBASSEMBLY

(b) Remove the 2 magnets from the oil pan.

REMOVE AUTOMATIC TRANSAXLE OIL PAN SUBASSEMBLY

(c) Examine particles in the pan.

(1) Collect any steel chips using the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.

Result: Steel (magnetic): Wear of the bearing, gear or plate Brass (non-magnetic): Wear of the bearing

5. DISCONNECT TRANSMISSION WIRE

DISCONNECT TRANSMISSION WIRE

(a) Disconnect the 7 shift solenoid valve connectors.

(b) Remove the bolt and lock plate, and disconnect the ATF temperature sensor.

6. REMOVE TRANSMISSION WIRE

REMOVE TRANSMISSION WIRE

(a) Disconnect the transmission wire connector.

(b) Remove the bolt and transmission wire.

(c) Remove the O-ring from the transmission wire.

Transmission Wire
COMPONENTS ...

Installation
1. INSTALL TRANSMISSION WIRE (a) Coat the O-ring of the transmission wire connector with ATF and install it. (b) Install the transmission wire with the bolt. Torque: 5.4 N*m (55 kgf*cm, 48 ...

Other materials:

Fog light switch
The fog lights secure excellent visibility in difficult driving conditions, such as in rain and fog. The illustration is intended as an example. Turns the fog lights on *1 or *2 Turns the fog lights off *1: For U.S.A. *2: For Canada Fog lights can be used when The headlights ...

Stereo Component Amplifier Communication Error
INSPECTION PROCEDURE 1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE Enter the diagnostic mode. Press the preset switch "3" to change to "Detailed Information Mode".  Identify the component shown by the sub-code. HINT:  "190 (radio receiver ...

Description of code registration
It is necessary to register the transmitter ID in the tire pressure warning ECU when replacing the tire pressure warning valve and transmitter and/or tire pressure warning ECU. (a) Before registration (1) In case of tire pressure warning ECU replacement. Read the registered transmitter I ...

В© 2011-2024 Copyright www.tsienna.net