1. REMOVE BATTERY
2. REMOVE AIR CLEANER ASSEMBLY
HINT: (See page EM-26)
3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Remove the nut from the control shaft lever.
(b) Disconnect the control cable from the control shaft lever.
(c) Remove the clip and disconnect the control cable from the control cable bracket.
NOTICE: Do not hold the resin guide pipe.
4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Disconnect the park/neutral position switch connector.
(b) Remove the nut, washer and control shaft lever
(c) Using a screwdriver, pry up the lock plate.
(d) Remove the lock nut and the lock plate.
(e) Remove the 2 bolts and pull out the park/neutral position switch.
Rear side sunshades
Rear door window
Rear quarter window
Pull the tab up.
Secure the sunshade using the hooks.
To retract the sunshade, pull the tab up slightly to unhook the sunshade,
and lower the sunshade slowly.
NOTICE
To ensure normal operation of the rear sunshades, observe ...
System Voltage
DTC P0560 System Voltage
MONITOR DESCRIPTION
The battery supplies electricity to the ECM even when the ignition switch is
off. This power allows the
ECM to store data such as DTC history, freeze frame data and fuel trim values.
If the battery voltage falls
below a minimum level, these memori ...
No Answer-Back (Hazard Warning Light and Wireless Door Lock
Buzzer)
DESCRIPTION
If there is no answer-back of the hazard light signal and the wireless door lock
buzzer although the
wireless control function is operating normally, there might be a malfunction in
the hazard light signal and
the wireless door lock buzzer signal which are output from the multiple ...