Toyota Sienna Service Manual: Removal
1. REMOVE ENGINE AND TRANSAXLE
HINT: (See page EM-26)
2. REMOVE AUTOMATIC TRANSMISSION WITH TRANSFER
HINT: (See page AX-164)
3. REMOVE TRANSFER ASSEMBLY
HINT: (See page TF-8)
4. REMOVE CTR DIFFERENTIAL LOCK SLEEVE
HINT: (See page TF-13)
5. REMOVE TRANSFER CASE OIL SEAL
(a) Using SST(s), remove the transfer case oil seal from the transfer case.
SST 09308-00010
NOTICE: Do not damage the oil-seal-fitted surface of the case.
Transfer case oil seal
COMPONENTS
...
Installation
1. INSTALL TRANSFER CASE OIL SEAL
(a) Using SST, install anew transfer case oil seal to the
transfer case at the position shown in the
illustration.
SST 09387-00010, 09950-70010 (09951-07150)
...
Other materials:
Installation
1. INSTALL POWER POINT SOCKET ASSEMBLY
Engage the 2 claws to install the power point socket
assembly.
2. INSTALL QUARTER TRIM FRONT PANEL ASSEMBLY
LH
3. INSTALL BACK DOOR SCUFF PLATE
4. INSTALL BACK DOOR WEATHERSTRIP
5. INSTALL REAR DOOR WEATHERSTRIP LH
6. INSTALL REAR DOOR S ...
For driver side
ON-VEHICLE INSPECTION
1. INSPECT AIR MIX CONTROL SERVO MOTOR
(a) Remove the air mix control servo motor.
(b) Connect the positive (+) lead from the battery to
terminal 4 and negative (-) lead to terminal 5, then
check that the lever turns to "COOL" side smoothly.
(c) Connect ...
Removal
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY
HINT:
Refer to the instructions for disassembly of the front seat assembly
(for flat type).
Refer to the instructions for disassembly of the front seat assembly
(for manual seat).
Refer to the instructions for disassembly of the fro ...
