Toyota Sienna Service Manual: Room light assembly
ON-VEHICLE INSPECTION
1. ROOM LIGHT ASSEMBLY NO.2
- Check that the resistance exists between the terminals.
Resistance: Below 1 Ω
2. INTERIOR DOME LIGHT SWITCH ASSEMBLY
- Check that there is resistance between the terminals at each switch position as shown in the chart.
Resistance
- Inspect illumination operation.
- Connect the battery positive (+) lead to the terminal 4 and the battery negative (-) lead to the terminal 1, and check that the illumination comes on.
Personal light assembly
ON-VEHICLE INSPECTION
1. ROOF CONSOLE BOX ASSEMBLY
Inspect map light assembly resistance.
Check the resistance between the terminals at
each switch position as shown in th ...
Door courtesy light (for Rear
Side)
ON-VEHICLE INSPECTION
1. REAR DOOR COURTESY LIGHT ASSEMBLY LH
Check that the exists between the terminals.
Resistance:
Below 1 Ω
2. REAR DOOR COURTESY LIGHT ASSEMBLY RH
...
Other materials:
Short in Front Pretensioner Squib RH Circuit
DTC B0130/63 Short in Front Pretensioner Squib RH Circuit
DESCRIPTION
The front pretensioner squib RH circuit consists of the center airbag sensor
assembly and the front seat
outer belt assembly RH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0130/63 ...
Inspection
1. INSPECT HEATED OXYGEN SENSOR (for Bank 1
Sensor 2)
(a) Measure the resistance of the sensor.
Standard resistance
If the resistance is not as specified, replace the
sensor.
2. INSPECT HEATED OXYGEN SENSOR (for Bank 2
Sensor 2)
(a) Measure the resistance of the sensor.
Standard r ...
Installation
1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Pull in the control cable to the body.
(b) Install the cable end, as shown in the illustration.
(c) When installing the transmission control cable
assembly on the shift lever plate, place the
projection of the shift cable downward to ...
