Toyota RAV4 manuals

Toyota Sienna Service Manual: Scratched / Reversed Disc

DTC 62-46 Scratched / Reversed Disc

DTC 63-46 Scratched / Reversed Disc

DESCRIPTION

DTC No.

DTC Detecting Condition

Trouble Area

62-46

Scratches or dirt is found on CD surface or CD is set upside down.
  • CD
  • Radio receiver

63-46

Scratches or dirt is found on CD surface or CD is set upside down.

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 CHECK THAT CD IS INSERTED PROPERLY

  1. Check whether or not the CD is inserted upside down.

OK: CD is properly inserted.

2 CHECK DISC

CHECK DISC

  1. Check that the disc is not deformed or cracked.

OK: No deformation or cracks on the disc.

3 DISC CLEANING

DISC CLEANING

  1. Disc cleaning
  1.  If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

NOTICE: Do not use a conventional record cleaner or anti-static preservative

4 CLEAR DTC

  1. Clear the DTCs

5 RECHECK DTC

  1. Recheck for DTCs and check if the same trouble occurs again.

OK: Malfunction disappears.

6 REPLACE DISC WITH ANOTHER AND RECHECK

  1. Replace the disc with another and recheck.
  1. Replace the disc with another normal one.
  2.  Clear the DTCs.
  3.  Recheck for DTCs and check if the same trouble occurs again.

OK: Malfunction disappears

END

Eject Error/ Elevator Error/ Clamp Error/ Eject Error/ Elevator Error/ Clamp Error
DTC 62-45 Eject Error DTC 62-51 Elevator Error DTC 62-52 Clamp Error DTC 63-45 Eject Error DTC 63-51 Elevator Error DTC 63-52 Clamp Error DESCRIPTION DTC No. DTC Detecting Con ...

High Temperature
DTC 62-47 High Temperature DTC 63-47 High Temperature DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 62-47 Sensor detects that CD unit temperature ...

Other materials:

Removal
1. REMOVE FRONT WHEELS 2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH (a) Remove the 2 nuts and front stabilizer link assembly LH. HINT: If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud. 3. REMOVE FRONT STABILIZER LINK ASSEMBLY RH HINT: Remove the ...

Removal
1. REMOVE V-BANK COVER SUB-ASSEMBLY (See page EM-28) 2. REMOVE NO. 1 ENGINE UNDER COVER (See page EM-26) 3. DRAIN ENGINE COOLANT (See page CO-6) 4. REMOVE FRONT WHEEL RH 5. REMOVE FRONT FENDER APRON SEAL RH 6. REMOVE V-RIBBED BELT (See page EM-6) 7. DISCONNECT NO. 2 RADIATOR HOSE (a) Di ...

Basic inspection
When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly a ...

В© 2011-2024 Copyright www.tsienna.net