DTC 44-46 Scratched / Reversed Disc
DESCRIPTION
DTC No. |
DTC Detecting Condition |
Trouble Area |
44-46 |
Scratches or dirt is found on DVD surface or DVD is set upside down. |
|
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.
1 CHECK THAT DISC IS INSERTED PROPERLY
OK: Disc is properly inserted.
2 CHECK DISC
OK: No deformation or cracks on the disc.
3 DISC CLEANING
NOTICE: Do not use a conventional record cleaner or anti-static preservative
4 CLEAR DTC
5 RECHECK DTC
OK: Malfunction disappears.
6 REPLACE DISC WITH ANOTHER AND RECHECK
OK: Malfunction disappears.
END
Outside vehicle
General maintenance
Check the parts of the vehicle described below on a daily
basis. Performing maintenance checks on the vehicle is the
owner's responsibility. The owner may take the vehicle to a
service center but it is recommended that the owner perform
the checks.
In most cases, special ...
Fuel Pump Primary Circuit
DESCRIPTION
This DTC is designed to detect a malfunction in the fuel pump (FUEL
PUMP) relay circuit. When the
system is normal, the battery voltage is applied to FPR terminal of the ECM
while the FUEL PUMP
relay is turned OFF. If the battery voltage is not applied to the FPR
ter ...
Initialization
1. ZERO POINT CALIBRATION
NOTICE:
Make sure that the front passenger seat is not
occupied before performing the operation.
HINT:
Perform the zero point calibration and sensitivity check if
any of the following conditions occur.
The occupant classification ECU is replaced.
A ...