INSPECTION PROCEDURE
1 CHECK DISPLAY SETTING
OK: Returns to normal.
END
2 CHECK CABIN
OK: Cabin is warmer than -20C (-4.0F).
3 CHECK COLOR BAR (DISPLAY CHECK MODE)
OK: Color bars match the displayed names.
4 CHECK NAVI COLOR BAR (NAVIGATION CHECK MODE)
OK: Color bars match the displayed names.
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Television Display Assembly Communication Error
INSPECTION PROCEDURE
1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE
Enter the diagnostic mode.
Press the preset switch "3" to change to "Detailed
Information Mode".
Identify the component shown by the sub-code.
HINT:
"190 (radio receiver)" ...
Confirmation of transmitter id registration
(a) Make sure that the ignition switch is off.
(b) Connect the intelligent tester to DLC3.
(c) Turn the ignition switch to the ON position.
(d) Select "TIREPRESS" by following the prompts
displayed on the intelligent tester.
(e) Confirm that the data of tire pressure of all ti ...
Disassembly
1. REMOVE COOLER DRYER
(a) Using a hexagon wrench 14 mm (0.55 in.), remove
the cap from the modulator.
(b) Remove the O-ring from the cap.
(c) Using needle nose pliers, remove the cooler dryer. ...