Toyota Sienna 2010-2024 Owners Manual: Seat belts
Make sure that all occupants are wearing their seat belts before driving the vehicle.
- Correct use of the seat belts
- Fastening and releasing the seat belt (except for the third center seat)
- Fastening the seat belt (for the third center seat)
- Releasing and stowing the seat belt (for the third center seat)
- Adjusting the seat belt shoulder anchor height (front and second outside Tip-up seats)
- Seat belt pretensioners (front seats)
- Pre-collision seat belts (front seats of vehicles with pre-collision system)
Correct use of the seat belts
Make sure that all occupants are wearing their seat belts before driving
the vehicle. Use a child restraint system appropriate for the child until the child
becomes large enough to properly wear the ...
Correct use of the seat belts
Extend the shoulder belt so that
it comes fully over the shoulder,
but does not come into contact
with the neck or slide off the
shoulder.
Position the lap belt as low as
possible o ...
Other materials:
MPX Body ECU Stop
DTC B1200 MPX Body ECU Stop
DESCRIPTION
This DTC is detected when communication between the multiplex network body
ECU and the multiplex
network gateway ECU stops for more than 10 seconds.
DTC No.
DTC Detection Condition
Trouble Area
B1200
Body ECU comm ...
Correct driving posture
Adjust the angle of the seatback so that you are sitting straight up and
so that you do not have to lean forward to steer.
Adjust the seat so that you can depress the pedals fully and so that
your arms bend slightly at the elbow when gripping the steering wheel.
Lock the head rest ...
Removal
HINT:
Remove the RH side by the same procedure as the LH side.
1. REMOVE REAR WHEEL
2. REMOVE QUARTER TRIM PANEL ASSEMBLY
FRONT LH
HINT:
Remove the LH side by the same procedure as the RH
side (See page IR-9).
3. REMOVE REAR SPEED SENSOR
(a) Disconnect the speed sensor connector, and pu ...
