If removing the second seats, it is possible to load extra cargo equal to the weight of the removed seats.
(Cargo capacity) = (Total load capacity) - (Total weight of occupants) + (Weight of the removed second seats) Second seats weight:
Tip-up seat, fabric: 47.2 lb. (20.5 kg) Tip-up seat, leather: 49.5 lb. (21.5 kg) Ottoman seat: 74.1 lb. (32.2 kg)
Right side, fabric: 47.2 lb. (20.5 kg) Right side, leather: 49.5 lb. (21.5 kg) Left side, fabric: 97.1 lb. (42.2 kg) Left side, leather: 100.3 lb. (43.6 kg)
WARNING Things that must not be carried in the luggage compartment The following things may cause a fire if loaded in the luggage compartment:
Storage precautions Observe the following precautions. Failure to do so may prevent the pedals from being depressed properly, may block the driver’s vision, or may result in items hitting the driver or passengers, possibly causing an accident.
Capacity and distribution
Cross rail adjustment Make sure the cross rails are locked securely by pushing forward and rearward them. Failure to do so may cause an unexpected accident. When loading cargo To use the roof rails as a roof luggage carrier, you must fit the roof rails with two or more genuine Toyota cross rails or their equivalent. When you load cargo on the roof luggage carrier, observe the following:
|
NOTICE When loading cargo (vehicles with moon roof) Be careful not to scratch the surface of the moon roof. |
Installation
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. INSTALL SIDE AIRBAG SENSOR LH
Check that the ignition switch is off.
Check that the battery negative (-) terminal is
disconnected.
CAUTION:
Afte ...
DSP Error/ DSP Error
DTC 62-78 DSP Error
DTC 63-78 DSP Error
DESCRIPTION
INSPECTION PROCEDURE
HINT:
After the inspection is completed, clear the DTCs.
NOTICE:
These codes may be output even if there is no malfunction.
If these codes are output frequently, replace the radio receiver.
1 CLEA ...
Short to B+ in Rear Curtain Shield Squib LH
Circuit
DTC B1638/86 Short to B+ in Rear Curtain Shield Squib LH
Circuit
DESCRIPTION
The rear curtain shield squib LH circuit consists of the center airbag sensor
assembly and the curtain
shield airbag assembly LH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B ...