Toyota Sienna Service Manual: Security Horn Circuit
DESCRIPTION
During the alarm sounding state, the relay in the ECU turns on and off in a cycle of approximately 0.2 seconds, causing the security horn to sound.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT SECURITY HORN ASSEMBLY
- Disconnect the T1 security horn connector.
- Check the operation of the security horn.
Standard
2 CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK BODY ECU - SECURITY HORN ASSEMBLY)
- Disconnect the B8 ECU connector.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
REPLACE MULTIPLEX NETWORK BODY ECU
Engine Hood Courtesy Switch Circuit
DESCRIPTION
The engine hood courtesy switch is built in the engine hood lock assembly.
The switch turns on when the
engine hood is opened and turns off when the engine hood is closed.
WIRING DIAG ...
Ignition Switch Circuit
DESCRIPTION
When the ignition switch is turned to the ON position, battery positive
voltage is applied to terminal IG of
the ECU. When battery positive voltage is applied to terminal IG of the ECU ...
Other materials:
Front Occupant Classification Sensor RH Collision
Detection
DTC B1786 Front Occupant Classification Sensor RH Collision
Detection
DESCRIPTION
DTC B1786 is output when the occupant classification ECU receives a collision
detection signal sent by
the front occupant classification sensor RH if an accident occurs.
DTC B1786 is also output when the front ...
Yaw Rate Sensor Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Yaw Rate Sensor
Communication Stop
Mode
"Yaw rate/ Deceleration sensor" is not displayed on
the "Communication Bus Check" screen of the
intelligent tester
Applies to & ...
Back Sonar Sensor LH Circuit
DESCRIPTION
An ultrasonic sensor consists of a sensor portion that transmits and receives
ultrasonic waves and a preamplifier
that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and
sends the received
signals to the clearance warning ECU.
WIRING DIAGRAM
INSPECTION PR ...
