Toyota Sienna 2010-2024 Owners Manual: Setting the vehicle speed
- Press the “ON-OFF” button to
activate the cruise control.
Cruise control indicator will come on*1 or will be displayed on the multi-information display*2.
Press the button again to deactivate the cruise control.
- Accelerate or decelerate the
vehicle to the desired speed,
and push the lever down to set
the speed.
“SET” indicator will come on*1 or will be displayed on the multi-information display*2.
The vehicle speed at the moment the lever is released becomes the set speed.
*1: Vehicles with monochrome display *2: Vehicles with color display
Summary of functions
Use cruise control to maintain a set speed without depressing the
accelerator pedal.
Indicators
Cruise control switch
...
Adjusting the set speed
To change the set speed, operate the lever until the desired set speed
is obtained.
Increases the speed
Decreases the speed
Fine adjustment: Momentarily
move the lever in the desired di ...
Other materials:
Transmission Error
DTC 01-DC Transmission Error
DESCRIPTION
HINT:
*1: This code may be stored if the engine is started, idled for 60 seconds and
then started again.
NOTICE:
Before starting troubleshooting, be sure to clear DTCs to erase
codes stored due to the
reasons described in the HINT ...
Removal
1. REMOVE BACK DOOR CENTER GARNISH
Using a clip remover, disengage the 5 clips to
remove the back door center garnish.
2. REMOVE REAR SPOILER
Disconnect the center stop light connector.
Remove the 3 nuts.
Using a clip remover, disengage the 2 clips to
remove the rear s ...
Display Signal Circuit between Television Display Assembly and Radio
and Navigation Assembly
DESCRIPTION
This circuit sends a DVD image signal from the television display assembly to
the radio and navigation
assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - TELEVISION
DISPLAY ASSEMBLY)
Disconnect the radio and n ...
