Toyota Sienna Service Manual: Sfi system
- Precaution
- Definition of terms
- System diagram
- How to proceed with troubleshooting
- Check for intermittent problems
- Basic inspection
- Registration
- Checking monitor status
- Readiness monitor drive pattern
- Problem symptoms table
- Terminals of ecm
- Diagnosis system
- Dtc check / clear
- Freeze frame data
- Check mode procedure
- Data list / active test
- Diagnostic trouble code chart
- Сamshaft timing oil control valve assembly
- Throttle body
- ECM
- Accelerator pedal rod
- Mass air flow meter
- Vvt sensor
Precaution
1. INITIALIZATION
NOTICE:
Perform RESET MEMORY (AT initialization) when
replacing the automatic transaxle assembly, engine
assembly or ECM (See page AX-16).
Perform REGISTRATIO ...
Other materials:
Basic inspection
(a) WHEN MEASURING RESISTANCE OF
ELECTRONIC PARTS
(1) Unless otherwise stated, all resistance
measurements should be made at an ambient
temperature of 20°C (68°F). Resistance
measurements may be inaccurate if measured
at high temperatures, i.e. immediately after the
vehicle has been running ...
Initialization
Items to initialize
The following items must be initialized for normal system operation
after such cases as the battery being reconnected, or maintenance
being performed on the vehicle.
Item
When to initialize
Power sliding door
(if equipped)
After reconnecting o ...
Short to GND in Driver Side Squib 2nd Step Circuit
DTC B1182/19 Short to GND in Driver Side Squib 2nd Step Circuit
DESCRIPTION
The driver side squib 2nd step circuit consists of the center airbag sensor
assembly, the spiral cable and
the steering pad.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1182/19 ...
