Toyota RAV4 manuals

Toyota Sienna 2010-2024 Owners Manual: Shift position purpose

Toyota Sienna. Shift position purpose


*1: Shifting to the D position allows the system to select a gear suitable for the driving conditions. Setting the shift lever to the D position is recommended for normal driving.

*2: Selecting shift ranges using S mode restricts the upper limit of the possible gear ranges, controls engine braking forces, and prevents unnecessary upshifting.

Shifting the shift lever
While the engine switch is in the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system), move the shift lever with the brake pedal de ...

Changing shift ranges in S mode
To enter S mode, shift the shift lever to S. Shift ranges can be selected by operating the shift lever, allowing you to drive in the shift range of your choosing. The shift range can be selected by ...

Other materials:

No. 2 Ultrasonic sensor
COMPONENTS REMOVAL 1. REMOVE REAR BUMPER COVER (2) 2. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER  Remove the No. 1 ultrasonic sensor retainer as shown in the illustration 3. REMOVE NO. 2 ULTRASONIC SENSOR  Disconnect the connector and remove the No. 2 ultrasonic ...

Problem symptoms table
HINT:  Use the table below to help determine the cause of the problem symptoms. The potential causes of the symptoms are listed in order of probability in the ''Suspected Area'' column of the table. Check each symptom by checking the suspected areas in the order they are listed. Rep ...

Installation
1. INSTALL FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH (a) Install the front lower arm bush stopper to the front suspension arm sub-assembly lower No.1 LH. (b) Install the bolt and nut to the rear side of the front suspension arm sub-assembly lower No.1 LH. Torque: 206 N*m (2,100 kgf ...

© 2011-2024 Copyright www.tsienna.net