DTC B0137/71 Short to GND in Front Pretensioner Squib LH Circuit
DESCRIPTION
The front pretensioner squib LH circuit consists of the center airbag sensor assembly and the front seat outer belt assembly LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0137/71 is recorded when a short to ground is detected in the front pretensioner squib LH circuit
DTC No. |
DTC Detecting Condition |
Trouble Area |
B0137/71 |
|
|
INSPECTION PROCEDURE
HINT:
1 CHECK FRONT SEAT OUTER BELT ASSEMBLY LH (FRONT PRETENSIONER SQUIB LH)
CAUTION: Never connect a tester to the front seat outer belt assembly LH (front pretensioner squib LH) for measurement, as this may lead to a serious injury due to airbag deployment.
NOTICE: Do not forcibly insert the SST into the terminals of the connector when connecting.
Insert the SST straight into the terminals of the connector.
SST 09843-18060
OK: DTC B0137/71 is not output. HINT: Codes other than DTC B0137/71 may be output at this time, but they are not related to this check.
Go to step 2
REPLACE FRONT SEAT OUTER BELT ASSEMBLY LH
2 FLOOR WIRE (FRONT PRETENSIONER SQUIB LH CIRCUIT)
Standard resistance
REPAIR OR REPLACE FLOOR WIRE
3 CHECK CENTER AIRBAG SENSOR ASSEMBLY
OK: DTC B0137/71 is not output. HINT: Codes other than DTC B0137/71 may be output at this time, but they are not related to this check.
REPLACE CENTER AIRBAG SENSOR ASSEMBLY
USE SIMULATION METHOD TO CHECK
Short to GND in Side Squib LH Circuit
DTC B0117/45 Short to GND in Side Squib LH Circuit
DESCRIPTION
The side squib LH circuit consists of the center airbag sensor assembly and
the front seat side airbag
assembly LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0117/45 is recorded when a s ...
On-vehicle inspection
NOTICE:
In this section, the terms "cold" and "hot" refer to the
temperature of the coils. "Cold" means approximately -
10°C (14°F) to 50°C (122°F). "Hot" means approximately
50°C (122°F) to 100°C (212°F).
1. INSPECT IGNITION C ...
Phone Display Settings
Display the “Phone/Message Settings” screen.
Select “Phone Display Settings”.
Select the desired item to be set.
Change the incoming call
display.
“Full Screen”: When a call is
received, the hands-free screen
is displayed and can be operated
on the screen.
...