DTC B1632/81 Short to GND in Rear Curtain Shield Squib RH Circuit
DESCRIPTION
The rear curtain shield squib RH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly RH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1632/81 is recorded when a short to ground is detected in the rear curtain shield squib RH circuit.
DTC No. |
DTC Detecting Condition |
Trouble Area |
B1632/81 |
|
|
INSPECTION PROCEDURE
HINT:
1 CHECK CURTAIN SHIELD AIRBAG ASSEMBLY RH (REAR CURTAIN SHIELD SQUIB RH)
CAUTION: Never connect a tester to the curtain shield airbag assembly RH (Rear curtain shield squib RH) for measurement, as this may lead to a serious injury due to airbag deployment.
NOTICE: Do not forcibly insert the SST into the terminals of the connector when connecting.
Insert the SST straight into the terminals of the connector.
SST 09843-18060
OK: DTC B1632/81 is not output. HINT: Codes other than DTC B1632/81 may be output at this time, but they are not related to this check.
Go to step 2
REPLACE CURTAIN SHIELD AIRBAG ASSEMBLY RH
2 CHECK FLOOR WIRE NO.2 (REAR CURTAIN SHIELD SQUIB RH CIRCUIT)
Standard resistance
REPAIR OR REPLACE FLOOR WIRE NO.2
3 CHECK CENTER AIRBAG SENSOR ASSEMBLY
OK: DTC B1632/81 is not output. HINT: Codes other than DTC B1632/81 may be output at this time, but they are not related to this check
REPLACE CENTER AIRBAG SENSOR ASSEMBLY
USE SIMULATION METHOD TO CHECK
Display
When the sensors detect an obstacle, the following displays inform
the driver of the position and distance to the obstacle.
Multi-information display
Front corner sensor operation
Rear corner sensor operation
Rear center sensor operation
Audio system screen
Intuitive parking ...
Unlocking and locking the doors from the inside
Door lock switch
Locks all the doors
Unlocks all the doors
Inside lock button
Locks the door
Unlocks the door
The front doors can be opened
by pulling the inside handle
even if the lock buttons are in
the lock position. ...
Hood
Release the lock from the inside of the vehicle to open the hood.
Pull the hood lock release lever.
The hood will pop up slightly.
Pull up the auxiliary catch lever
and lift the hood.
Hold the hood open by inserting
the supporting rod into the slot
WARNING ...