Toyota Sienna Service Manual: Skid Control ECU Communication Stop Mode

Toyota Sienna Service Manual / Can communication / Can communication system / Fail-safe chart / Skid Control ECU Communication Stop Mode

DESCRIPTION

Detection Item	Symptom	Trouble Area
Skid Control ECU Communication Stop Mode	"ABS/VSC/TRC" is not displayed on the "Communication Bus Check" screen of the intelligent tester Applies to "Skid Control ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"	Power source circuit of skid control ECU Skid control ECU branch wire or connector Skid control ECU with Actuator

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:

Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT: Operating the ignition switch, any switches, or any doors triggers related ECU and sensor communication with the CAN. This communication will cause the resistance value to change.

1 CHECK OPEN IN CAN BUS WIRE (SKID CONTROL ECU BRANCH WIRE)

CHECK OPEN IN CAN BUS WIRE (SKID CONTROL ECU BRANCH WIRE)

Turn the ignition switch off.
Disconnect the skid control ECU with Actuator connector.
Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

2 CHECK WIRE HARNESS (IG1, GND1, GND2)

CHECK WIRE HARNESS (IG1, GND1, GND2)

Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

Measure the voltage according to the value(s) in the table below.

Standard voltage

REPLACE ABS & TRACTION ACTUATOR ASSEMBLY

Fail-safe chart

1. FAIL-SAFE FUNCTION When communication fails in any of the main wires (communication lines) due to a short circuit or other causes, the fail-safe function, which is specified for each syst ...

Distance Control ECU Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Distance Control ECU Communication Stop Mode Distance control" is not displayed on the &qu ...

Other materials:

ACIS Control Circuit
DESCRIPTION This circuit opens and closes the Intake Air Control Valve (IACV) in response to changes in the engine load in order to increase the intake efficiency (ACIS: Acoustic Control Induction System). When the engine speed is between 0 and 4450 rpm and the throttle valve opening angl ...

Using a flatbed truck
If you use chains or cables to tie down your vehicle, the angles shaded in black must be 45. Do not overly tighten the tie downs or the vehicle may be damaged. WARNINGObserve the following precautions. Failure to do so may result in death or serious injury. When tow ...

Engine oil
With the engine at operating temperature and turned off, check the oil level on the dipstick. Checking the engine oil Park the vehicle on level ground. After warming up the engine and turning it off, wait more than 5 minutes for the oil to drain back into the bottom of the engine. Ho ...