DTC B1796 Sleep Operation Failure of Occupant Classification ECU
DESCRIPTION
During sleep mode, the occupant classification ECU reads the condition of each sensor while the ignition switch is off.
In this mode, if the occupant classification ECU detects an internal malfunction, DTC B1796 is output.
INSPECTION PROCEDURE
1 CHECK DTC
HINT: First clear DTCs stored in the occupant classification ECU and then in the center airbag sensor assembly.
OK: DTC B1796 is not output.
HINT: Codes other than DTC B1796 may be output at this time, but they are not related to this check.
2 REPLACE OCCUPANT CLASSIFICATION ECU
3 PERFORM ZERO POINT CALIBRATION
OK: The "COMPLETED" is displayed.
4 PERFORM SENSITIVITY CHECK
Standard values: 27 to 33 kg (59.52 to 72.75 lb)
END
Drive belt
COMPONENTS
REMOVAL
1. REMOVE FRONT WHEEL RH
2. REMOVE FRONT FENDER APRON SEAL RH (See
page EM-26)
3. REMOVE V-RIBBED BELT
(a) Using SST, release the belt tension by turning the
belt tensioner counterclockwise, and remove the Vribbed
belt from the belt tensioner.
SST 09249-63010
(b) ...
Short to GND in CAN Bus Line
DESCRIPTION
A short to GND is suspected in the CAN bus wire when the resistance between
terminals 4 (CG) and 6
(CANH), or terminals 4 (CG) and 14 (CANL) of the DLC3 is below 200 Ω.
Symptoms
Trouble Area
The resistance between terminals 6 (CANH) and 4 (CG), or ter ...
Road test
1. PROBLEM SYMPTOM CONFIRMATION
HINT:
The dynamic laser cruise control system has two cruise
control modes: the constant speed control mode and
vehicle-to-vehicle distance control mode.
The vehicle-to-vehicle distance control mode is
always selected when starting up the dynamic laser ...