Toyota Sienna Service Manual: Slide door

Reassembly

1. INSTALL FRONT DOOR WIRE LH Install the wire with the 2 bolts. Torque: Reference 8.0 N*m (82 kgf*cm, 71 in.*lbf) NOTICE: In order to prevent water leakage, be sure that the lip of t ...

Removal

HINT: On the RH side, use the same procedures as on the LH side. 1. REMOVE SLIDE DOOR Remove the rear door scuff plate (See page IR-7). Remove the back door scuff plate (See page ED- 214 ...

Other materials:

Removal
1. Remove rear wheel 2. Remove skid control sensor wire (for 2wd) Hint: (see page sp-38) hint: disconnect the rh side by the same procedures as the lh side. 3. SEPARATE SPEED SENSOR REAR LH (for 4WD) HINT: (See page SP-38) 4. SEPARATE SPEED SENSOR REAR RH (for 4WD) HINT: Separate the RH ...

Test mode procedure
1. SPEED SENSOR SIGNAL CHECK (WHEN USING SST CHECK WIRE): HINT: If the ignition switch is turned from the ON to the ACC or LOCK position during Test Mode, the DTCs of the signal check function will be erased. (a) Turn the ignition switch off. (b) Check that the steering wheel is in th ...

Mirror Switch Circuit
DESCRIPTION  A switch signal of the outer mirror switch is transmitted to the selected outer mirror control ECU by way of the body ECU. Then, the outer mirror control ECU activates the mirror motor to move the mirror UP, DOWN, RIGHT and LEFT in response to the inputs. HINT: Th ...