Toyota Sienna Service Manual: Slide Door Closer LH does not Operate
DESCRIPTION
The slide door ECU LH controls the slide door closer. In response to the output signals from the switches in the slide door lock, the slide door closer drives the closer motor.
HINT: The slide door closer system operates regardless of the power slide door main switch ON / OFF.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT FUSE (ECU-B)
- Inspect the ECU-B fuse
2 INSPECT SLIDE DOOR LOCK
- Check that the slide door fully closes (fully locked) when the door is closed by hand.
3 POWER SOURCE RESET
- Disconnect the ECU-B fuse and reconnect it. 10 seconds later, check that the slide door closer is operational.
4 INSPECT POWER SLIDE DOOR LOCK ASSEMBLY
- Apply battery voltage to the terminals and check the motor operation.
OK
- At each range of the latch, inspect the resistance of the pawl switch and latch switch.
Resistance
- Inspect the resistance of the original position switch and handle switch.
Resistance
5 CHECK WIRE HARNESS (POWER SLIDE DOOR LOCK ASSEMBLY - POWER SLIDE DOOR ECU LH)
- Disconnect the P29 door lock and P25 ECU connectors.
- Check the resistance between the wire harness connectors.
Resistance (Check for open circuit)
- Check the resistance between the P29 lock connector and body ground.
Resistance (Check for open circuit)
REPLACE POWER SLIDE DOOR ECU LH
Data list / active test
1. DATA LIST
HINT:
Using the DATA LIST displayed on the intelligent tester,
you can read the value of the switch, sensor, actuator,
etc. without parts removal. Reading the DATA LIST as
the first ...
Slide Door Closer RH does not Operate
DESCRIPTION
The slide door ECU RH controls the slide door closer. In response to the
signals output from the switches
in the slide door lock, the slide door closer drives the closer motor.
HINT:
...
Other materials:
Front Occupant Classification Sensor RH Circuit
Malfunction
DTC B1781 Front Occupant Classification Sensor RH Circuit
Malfunction
DESCRIPTION
The front occupant classification sensor RH circuit consists of the occupant
classification ECU and the
front occupant classification sensor RH.
DTC B1781 is recorded when a malfunction is detected in the fron ...
ECM / PCM Processor
DTC P0606 ECM / PCM Processor
DESCRIPTION
The ECM continuously monitors its internal processors (CPUs), A/F sensor
transistors and heated oxygen
sensor (HO2S) transistors. This self-check ensures that the ECM is functioning
properly. These are
diagnosed by internal "mirroring" of t ...
Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance
Problem
HINT:
This DTC relates to the Throttle Position (TP) sensor.
DESCRIPTION
Refer to DTC P0120 (See page ES-145).
MONITOR DESCRIPTION
The ECM uses the TP sensor to monitor the throttle valve opening angle.
This sensor transmits two signals: VTA1 and VTA2. VTA1 is used to detect the
th ...
