DESCRIPTION
The slide door ECU RH controls the slide door closer. In response to the signals output from the switches in the slide door lock, the slide door closer drives the closer motor.
HINT: The slide door closer system operates regardless of the power slide door main switch ON / OFF.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT FUSE (ECU-B)
2 INSPECT SLIDE DOOR LOCK
3 POWER SOURCE RESET
4 INSPECT POWER SLIDE DOOR LOCK ASSEMBLY RH
OK
Resistance
Resistance
5 CHECK WIRE HARNESS (POWER SLIDE DOOR LOCK ASSEMBLY RH - POWER SLIDE DOOR ECU RH)
Resistance (Check for open circuit)
Resistance (Check for open circuit)
REPLACE POWER SLIDE DOOR ECU RH
Door control transmitter
INSPECTION
1. INSPECT DOOR CONTROL TRANSMITTER
Inspect operation of the transmitter.
Remove the battery (lithium battery) from the transmitter.
Install a new or normal battery (lithium battery).
When a new or normal battery is not available,
connect 2 new ...
Inspection
1. INSPECT UNDERDRIVE PACK CLEARANCE
(a) Install the underdrive clutch to the transaxle case.
NOTICE:
Be careful not to damage the oil seal rings.
(b) Install a dial indicator as shown in the illustration.
(c) Measure the underdrive clutch pack clearance while
applying and releasing comp ...
On-vehicle inspection
NOTICE:
In this section, the terms "cold" and "hot" refer to the
temperature of the coils. "Cold" means approximately -
10°C (14°F) to 50°C (122°F). "Hot" means approximately
50°C (122°F) to 100°C (212°F).
1. INSPECT IGNITION C ...