Toyota Sienna 2010-2026 Owners Manual: Sliding doors

Toyota Sienna 2010-2026 Owners Manual / Operation of each component / Opening, closing and locking the doors / Sliding doors

Vehicles without power sliding doors The sliding doors can be opened and closed using the sliding door handle. The sliding door can be locked and unlocked using the wireless remote control, door lock switch or inside lock knob.
Vehicles with power sliding doors The power sliding doors can be opened and closed using the sliding door handle, power sliding door switches or wireless remote control. The power sliding doors can be locked and unlocked using the wireless remote control, door lock switch or inside lock knob.

Automatic door locking and unlocking systems

The following functions can be set or cancelled: For instructions on customizing, refer to Function Operation Shift position linked door locking function Shifting the shif ...

Locking/unlocking the sliding door from

Entry function (vehicles with a smart key system) Carry the electronic key to enable this function. Pull the handle to unlock all the doors. There is no touch type sensor in slide door ha ...

Other materials:

Rear side sunshades
Rear door window Rear quarter window Pull the tab up. Secure the sunshade using the hooks. To retract the sunshade, pull the tab up slightly to unhook the sunshade, and lower the sunshade slowly. NOTICE To ensure normal operation of the rear sunshades, observe ...

Check mode procedure
HINT: Check mode has a higher sensitivity to malfunctions and can detect malfunction that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1-trip detection logic. Dtc check (check mode) HINT: I ...

Cranking Holding Function Circuit
DESCRIPTION The system detects the ignition switch's starting signal (STSW) and then supplies current to the starter until the ECM judges that the engine has started successfully. The purpose is to reduce the holding time of the ignition key. WIRING DIAGRAM Refer to DTC P0617 (See page ...