DESCRIPTION
The clearance warning ECU receives the vehicle speed signal from the combination meter.
HINT:
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK OPERATION OF SPEEDOMETER
OK: Actual vehicle speed and the speed indicated on the speedometer are the same.
HINT: The vehicle speed signal is normal when the indication on the speedometer is normal.
2 INSPECT CLEARANCE WARNING ECU
OK: Voltage pulses as shown.
3 CHECK HARNESS AND CONNECTOR (COMBINATION METER - CLEARANCE WARNING ECU)
Standard resistance
4 CHECK HARNESS AND CONNECTOR (COMBINATION METER AND EACH ECU - BODY GROUND)
Standard resistance
HINT: If the resistance between terminal SPD and body ground is less than 10 kΩ, there may be a short in a wire harness, connector, or ECU.
REPLACE COMBINATION METER
Installation
1. INSTALL BRAKE VACUUM CHECK VALVE
ASSEMBLY
(a) Install the brake vacuum check valve assembly and
check valve grommet to the brake booster
assembly.
2. INSTALL BRAKE BOOSTER GASKET
(a) Install a new brake booster gasket to the brake
booster with master cylinder.
3. INSTALL BRAKE MASTER CYLI ...
Transmission Fluid Temperature Sensor "A"
DESCRIPTION
The ATF (Automatic Transmission Fluid) temperature sensor converts the fluid
temperature into a
resistance value which is input into the ECM.
The ECM applies a voltage to the temperature sensor through ECM terminal THO1.
The sensor resistance changes with the transmission f ...
Removal
1. REMOVE REAR DOOR SCUFF PLATE LH
2. REMOVE REAR DOOR WEATHERSTRIP LH
3. REMOVE BACK DOOR WEATHERSTRIP
4. REMOVE BACK DOOR SCUFF PLATE
5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY LH
6. REMOVE POWER POINT SOCKET ASSEMBLY
Release the 2 claw fittings and remove the power
point soc ...