DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK BATTERY
Standard voltage: 11 to 14 V
CHECK AND REPLACE BATTERY OR CHARGING SYSTEM
2 CHECK CONNECTORS
OK: The connectors are properly connected.
CONNECT CONNECTORS
3 CHECK WIRE HARNESS (SOURCE VOLTAGE OF COMBINATION METER ASSEMBLY)
Standard voltage
Standard Resistance
REPAIR OR REPLACE WIRE HARNESS
4 CHECK SRS WARNING LIGHT
OK: After the primary check period, SRS warning light goes off for approximately 10 seconds, and remains on. HINT: The primary check period is approximately 6 seconds after the ignition switch is turned to the ON position.
REPLACE COMBINATION METER ASSEMBLY
REPLACE CENTER AIRBAG SENSOR ASSEMBLY
Driving tips
Winter driving tips
Carry out the necessary preparations and inspections before
driving the vehicle in winter. Always drive the vehicle in a manner
appropriate to the prevailing weather conditions.
Preparation for winter
Use fluids that are appropriate to the prevailing outside temperatures. ...
Definition of terms
Terms
Definitions
Monitor Description
Description of what ECM monitors and how to detect malfunctions
(monitoring purpose and details).
Related DTCs
A group of diagnostic trouble codes that are output by ECM based on
the same malfunction detection lo ...
Short in Rear Curtain Shield Squib LH Circuit
DTC B1635/87 Short in Rear Curtain Shield Squib LH Circuit
DESCRIPTION
The rear curtain shield squib LH circuit consists of the center airbag sensor
assembly and the curtain
shield airbag assembly LH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1635/87 ...