Toyota Sienna Service Manual: Starter

Starting system

Parts location System diagram The starting system rotates the starter motor according to the signals from the ignition switch and pnp switch. ...

Removal

1. REMOVE BATTERY (See page EM-26) 2. REMOVE NO. 2 AIR CLEANER INLET (See page EM- 28) 3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (See page FU-13) 4. REMOVE AIR CLEANER FILTER ELEMENT (See page EM-2 ...

Other materials:

Rear Clearance Sonar Sensor LH Circuit
DESCRIPTION An ultrasonic sensor consists of a sensor portion that transmits and receives ultrasonic waves and a preamplifier that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and sends the received signals to the clearance warning ECU. WIRING DIAGRAM INSPECTION PR ...

On-vehicle inspection
1. INSPECT MASS AIR FLOW METE NOTICE:  Perform the mass air flow (MAF) meter inspection by following the procedures below.  Only replace the MAF meter when the MAF value in the DATA LIST (with the engine stopped) are not within the normal operating range or there is fore ...

Short in Rear Curtain Shield Squib RH Circuit
DTC B1630/83 Short in Rear Curtain Shield Squib RH Circuit DESCRIPTION The rear curtain shield squib RH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly RH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1630/83 ...