Toyota RAV4 manuals

Toyota Sienna Service Manual: Stereo Component Amplifier Communication Error

Toyota Sienna Service Manual / Navigation / Navigation system / Diagnostic trouble code chart / Stereo Component Amplifier Communication Error

INSPECTION PROCEDURE

1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE

 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE

  1. Enter the diagnostic mode.
  2.  Press the "LAN Mon" switch to change to "LAN Monitor" mode.
  3.  Identify the component shown by the sub-code.

HINT:

2 CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE

  1. Inspect the power source circuit of the component shown by the sub-code.

    If the power source circuit is operating normally, proceed to the next step.

Component Table:

3 CHECK RADIO AND NAVIGATION ASSEMBLY

 CHECK RADIO AND NAVIGATION ASSEMBLY

  1. Disconnect the radio and navigation assembly connectors.
  2.  Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

4 CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMPONENT SHOWN BY SUB-CODE)

HINT:

  1.  Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the stereo component amplifier and the component shown by the sub-code.
  1.  Disconnect all connectors between the stereo component amplifier and the component shown by sub-code.
  2.  Check for an open or short in the AVC-LAN circuit between the stereo component amplifier and the component shown by the sub-code.

CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMPONENT SHOWN BY SUB-CODE)

OK: There is no open or short circuit.

5 REPLACE COMPONENT SHOWN BY SUB-CODE

  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

OK: Same problem does not occur

END

Microphone Circuit between Microphone and Radio and Navigation Assembly
DESCRIPTION This circuit sends a microphone signal from the microphone to the radio and navigation assembly. It also supplies power from the radio and navigation assembly to the microphone. WIR ...

Radio and Navigation Assembly Communication Error
INSPECTION PROCEDURE 1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE Enter the diagnostic mode.  Press the "LAN Mon" switch to change to "LAN Monitor" mode. &nbs ...

Other materials:

Front passenger occupant classification system
Your vehicle is equipped with a front passenger occupant classification system. This system detects the conditions of the front passenger seat and activates or deactivates the devices for the front passenger. SRS warning light Seat belt reminder light “AIR BAG OFF” indicator light ...

Installation
1. INSTALL TIRE PRESSURE WARNING RESET SWITCH (a) Engage the 2 claws to install the tire pressure warning reset switch to the lower instrument panel finish panel sub-assembly LH. 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH 3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH 4. IN ...

Jam Protection Function Activates During Power Slide Door LH Operation
DESCRIPTION  It may be caused by ill-fitting slide door, faulty touch sensor or faulty pulse sensor.  The power slide door ECU activates the slide motor to open / close the power slide door, thus controlling the power slide door operation. For jam and foreign object detect ...

© 2011-2024 Copyright www.tsienna.net