COMPONENTS
ON-VEHICLE INSPECTION
1. INSPECT STEREO COMPONENT SPEAKER
HINT: Remove interior parts so that the stereo component speaker can be seen.
OK: The speaker is securely installed.
If the result is not as specified, reinstall the stereo component speaker speaker.
OK: The cone paper of the speaker is not torn.
If the result is not as specified, replace the stereo component speaker speaker.
Standard resistance: 1.2 to 2.2 Ω
If the result is not as specified, replace the stereo component speaker speaker.
REMOVAL
1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
2. REMOVE STEREO COMPONENT SPEAKER ASSEMBLY
INSTALLATION
1. INSTALL STEREO COMPONENT SPEAKER ASSEMBLY
NOTICE: Tighten the screws in order shown in the illustration to install the stereo component speaker assembly.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH
Center Airbag Sensor Assembly Communication
Circuit Malfunction
DTC B1790 Center Airbag Sensor Assembly Communication
Circuit Malfunction
DESCRIPTION
The center airbag sensor assembly communication circuit consists of the
occupant classification ECU and
the center airbag sensor assembly.
DTC B1790 is recorded when a malfunction is detected in the center ...
Installation
1. INSTALL SPIRAL CABLE
Check that the front wheels are facing straight
ahead.
Set the turn signal switch to the neutral position.
NOTICE:
If it is not in the neutral position, the pin of the
turn signal switch may snap.
Install the spiral cable.
NOTICE:
When ...
Installation
1. INSTALL REAR NO. 2 SEAT ASSEMBLY
Lock the seat leg rear to the floor striker.
Lock the seat leg front to the floor striker.
Install the rear No. 2 seat assembly with the 8 bolts.
Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
NOTICE:
Tighten the bolts in the order sho ...