Toyota Sienna 2010-2024 Owners Manual: Stowing the third seats (manual seats)
Before stowing or returning third seat, remove any items from the floor area to prevent interference with moving parts.
Before stowing the third seats
- Lower the center head restraint to the lowest position , and stow the seat belt buckles.
- Stow the center seat belt.
Stowing the third seats
- Pull the handle to move the
seat rearward. Then push the
seat down.
The outside head restraints are folded automatically.
- Push the seat against the
floor.
Open the flaps.
Before returning the third seats
Be sure to move the second seats forward from the rearmost position, as they may interfere with the third seats returning operation.
Returning the third seats
- Return the flaps.
Pull the handle and lift up the seat rearward.
- Push the seat forward and
then engage the front leg
locks.
Make sure the front and rear legs are locked securely.
- Raise the seatback and the outside head restraints
Folding down the third seats (power seats)
You can operate the power third seats when the shift lever is in P.
Before folding the third seats
Lower the center head
restraint to the lowest position and stow the
seat belt buckles.
...
Stowing the third seats (power seats)
You can operate the power third seats when the shift lever is in P.
Before stowing or returning third seat, remove any items from the floor
area to prevent interference with moving parts.
Before ...
Other materials:
Parking Brake Switch Circuit
DESCRIPTION
This circuit is from the parking brake switch to the radio and navigation
assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK BRAKE WARNING LIGHT
Check that the brake warning light comes on when the
parking brake is applied and goes off when it is released.
OK:
The ...
Solar Sensor Circuit (Driver Side)
DESCRIPTION
The solar sensor, which is installed on the upper side of the instrument
panel, detects sunlight and
controls the air conditioning in AUTO mode. The output voltage from the solar
sensor varies according to
the amount of sunlight. When the sunlight increases, the output voltage ...
DTC check / clear
HINT: If the system cannot enter the diagnostic mode,
inspect all AVC-LAN communication signals and repair or replace problem parts.
1. STARTING DIAGNOSTIC MODE
Turn the ignition switch to the ACC position.
Turn off the audio system.
While pressing the preset switche ...
