Toyota Sienna Service Manual: Supplemental restraint system
- Airbag system
- Precaution
- Parts location
- System description
- How to proceed with troubleshooting
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Check mode procedure
- Data list / active test
- Diagnostic trouble code chart
- Occupant classification system
- Precaution
- System description
- How to proceed with troubleshooting
- Initialization
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Data list / active test
- Diagnostic trouble code chart
- Steering pad
- Spiral cable
- Front passenger airbag assembly
- Curtain shield airbag assembly
- Front seat side airbag assembly
- Sruepsptrleaminetnstal restraint system center airbag sensor assembly
- Front airbag sensor
- Side airbag sensor
- Rear airbag sensor
- Seat position sensor
- Occupant classification ECU
Installation
1. INSTALL INTEGRATION CONTROL AND PANEL
ASSEMBLY
2. INSTALL RADIO RECEIVER WITH BRACKET (w/
Navigation System)
3. INSTALL RADIO RECEIVER WITH BRACKET (w/o
Navigation System)
4. INSTALL INSTRUME ...
Airbag system
...
Other materials:
Power outlets
The power outlet can be used for the following components:
12 V: Accessories that run on less than 10 A
120 V AC: Accessories that use less than 100 W
12 V
Open the cover.
Center panel type A
Center panel type B
Luggage compartment
120 V AC (if equipped)
Open the ...
How to proceed with troubleshooting
Hint:
The ecm of this system is connected to the can and
multiplex communication system. Therefore, before
starting troubleshooting, make sure to check that there is
no trouble in the can and multiplex communication
systems
The intelligent tester can be used at steps 3, 4, 6, and 9.
...
Indicators
The indicators inform the driver of the operating state of the vehicle’s
various systems.
*1: If equipped
*2: These lights turn on when the engine switch is turned to the “ON” position
(vehicles without a smart key system) or IGNITION ON mode (vehicles
with a smart key system) to ...
