Toyota RAV4 manuals

Toyota Sienna Service Manual: Symptom confirmation and diagnostic trouble code

HINT:

The diagnostic system in the SIENNA has various functions.

Symptom confirmation and diagnostic trouble code

Symptom confirmation and diagnostic trouble code

  1. DTC CHECK

  1. MAKE A NOTE OF DTCS DISPLAYED AND THEN CLEAR MEMORY

  1. SYMPTOM CONFIRMATION

Result

  1. SIMULATION TEST USING SYMPTOM SIMULATION METHODS

  1. DTC CHECK

Result

  1. SYMPTOM CONFIRMATION

Result

If a DTC was displayed in the initial DTC check, the problem may have occurred in a wire harness or connector in that circuit in the past. Check the wire harness and connectors.

TROUBLESHOOTING OF EACH PROBLEM SYMPTOM

The problem still occurs in a place other than the diagnostic circuit (the DTC displayed first is either for a past problem or a secondary problem).

Customer problem analysis
HINT: In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand w ...

Symptom simulation
HINT: The most difficult case in troubleshooting is when no problem symptoms occur. In such a case, a thorough problem analysis must be carried out. A simulation of the same or similar conditions ...

Other materials:

Safety Connect LED light Indicators
When the engine switch is turned to the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system), the red indicator light comes on for 2 seconds then turns off. Afterward, the green indicator light comes on, indicating that the service is act ...

Reassembly
1. INSTALL FRONT DOOR WIRE LH Install the wire with the 2 bolts. Torque: Reference 8.0 N*m (82 kgf*cm, 71 in.*lbf) NOTICE: In order to prevent water leakage, be sure that the lip of the rubber grommet does not turn up or is not deformed when installing the wire. Connect the wir ...

TRAC OFF Indicator Light does not Come ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN and multiplex communications. When the traction OFF switch is turned on, the TRAC OFF indicator light will come on (for 2WD model). WIRING DIAGRAM Refer to TRAC OFF Indicator Light Remains ON (See page BC-157). ...

© 2011-2024 Copyright www.tsienna.net