1. DESCRIPTION OF OCCUPANT CLASSIFICATION SYSTEM
Reassembly
1. INSTALL CENTER SUPPORT BEARING ASSEMBLY NO.1
(a) Set the center support bearing assembly No. 1
(front) to the intermediate shaft, as shown in the
illustration.
(b) Install a new washer to the intermediate shaft.
NOTICE:
Be sure to install the bearing in the correct
direction.
(c ...
Stowing the flat tire
Take out the strap and tire bag.
Place tire standing up in rear
tub, after putting the tire in the
tire bag.
Clip clasp to outboard hook.
Clip other clasp to center or
opposite hook location.
Pull strap to tighten and secure
tire.
...
Installation
1. INSTALL TRANSFER CASE OIL SEAL
(a) Using SST, install anew transfer case oil seal to the
transfer case at the position shown in the
illustration.
SST 09387-00010, 09950-70010 (09951-07150)
NOTICE:
Do not install it obliquely.
(b) Apply small amount of MP grease to the oil seal lip.
2. ...