1. BRIEF DESCRIPTION
2. DEFINITION OF TERMS
This is the main bus in the CAN communication system.
These resistors allow the changes of the voltage differential between the CAN bus wires to be accurately judged. To allow for proper function of CAN communication, it is necessary to have both terminating resistors installed. Since the two resistors are installed in parallel, a measurement of resistance between the two CAN bus wires should produce a reading of approximately 60 Ω.
3. ECUS OR SENSORS WHICH COMMUNICATE THROUGH CAN COMMUNICATION SYSTEM
HINT:
*1: with VSC
*2: with Dynamic laser cruise control
4. DIAGNOSTIC CODE FOR CAN COMMUNICATION SYSTEM
HINT: If U0235 or U1102 is output alone, the CAN communication in normal (See page CC-88 forU0235, See page CC-91 for U1102).
5. TROUBLESHOOTING REMARKS
NOTICE: Do not insert the tester probes directly into the DLC3. Be sure to use a service wires.
Short to B+ in Front Passenger Side Squib Circuit
DTC B0108/52 Short to B+ in Front Passenger Side Squib Circuit
DESCRIPTION
The front passenger side squib circuit consists of the center airbag sensor
assembly and the front
passenger airbag assembly.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0108/52 ...
Inspection
1. INSPECT OIL PUMP ASSEMBLY
(a) Turn the drive gear with the 2 screwdrivers and
make sure that it rotates smoothly.
NOTICE:
Be careful not to damage the oil seal lip.
2. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY
(a) Push the driven gear to one side of the body.
(b) Using ...
Rear axle hub bolt
COMPONENTS
Replacement
HINT:
Replace the RH side using the same procedures as for the
LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER
ASSEMBLY LH
(a) Separate rear disc brake caliper assembly LH for
2WD and disk rear brake type (See page AH-16).
3. SEPARATE REAR D ...