COMPONENTS
REMOVAL
1. REMOVE BACK DOOR GARNISH CENTER
HINT:
2. REMOVE BACK DOOR SIDE GARNISH LH
HINT:
3. REMOVE BACK DOOR SIDE GARNISH RH
4. REMOVE BACK DOOR PULL STRAP
5. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
6. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
7. REMOVE TELEVISION CAMERA ASSEMBLY
INSTALLATION
1. INSTALL TELEVISION CAMERA ASSEMBLY
2. INSTALL BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
4. INSTALL BACK DOOR PULL STRAP
HINT:
5. INSTALL BACK DOOR SIDE GARNISH RH
6. INSTALL BACK DOOR SIDE GARNISH LH
7. INSTALL BACK DOOR GARNISH CENTER
Installation
1. INSTALL FOG LIGHT ASSEMBLY
Install the fog light assembly with the 2 claws and 2
pins.
2. INSTALL FRONT BUMPER ASSEMBLY
3. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
4. VEHICLE PREPARATION FOR FOG LIGHT AIMING
5. PREPARATION FOR FOG LIGHT AIMING
6. FOG LIGHT AIMING INSPECT ...
Brake Switch
DTC P0504 Brake Switch "A" / "B" Correlation
DTC P0724 Brake Switch "B" Circuit High
DESCRIPTION
The stop light switch is a duplex system that transmits two signals: STP and
ST1-. These two signals are
used by the ECM to monitor whether or not the brake system is ...
Power slide door main switch
INSPECTION
1. INSPECT POWER SLIDE DOOR MAIN SWITCH
Inspect the resistance of the switch.
Resistance
If the result is not as specified, replace the switch.
Apply battery voltage and check the illuminates.
Standard
HINT:
Whether the switch illuminates or not will not affect
...