INSPECTION PROCEDURE
1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE
HINT:
2 CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
If the power source circuit is operating normally, proceed to the next step
Component Table:
3 INSPECT RADIO RECEIVER
Standard resistance
*1: 10 Speaker System
4 CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - COMPONENT SHOWN BY SUB-CODE)
HINT:
OK: There is no open or short circuit
5 REPLACE COMPONENT SHOWN BY SUB-CODE
OK: Same problem does not occur.
END
DTC check / clear
1. CHECK DTC (USING INTELLIGENT TESTER)
Checking DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Read DTCs by following the prompts on the
tester screen.
HINT:
Refer to the intelligent tester operator's manual
for further details.
2. CLEAR DTC ...
Command list
Some recognizable voice commands and their actions are shown
below as examples.
Basic
Command
Action
“Help”
Prompts voice guidance to offer examples of commands
or operation methods
“Go Back”
Returns to the previous screen
Phone
...
Safety Connect
Safety Connect is a subscription-based telematics service that
uses Global Positioning System (GPS) data and embedded cellular
technology to provide safety and security features to subscribers.
Safety Connect is supported by Toyota’s designated
response center, which operates 24 hours per da ...