Toyota Sienna Service Manual: Terminals of ecm
1. Ecm
Hint: each ecm terminal's standard voltage is shown in the table below.
In the table, first follow the information under "condition".
Look under "symbols (terminal no.)" For the terminals to inspected. The standard voltage between the terminals is shown under "specific condition".
Use the illustration above as a reference for the ecm terminals.
(a) Waveform 1
Reference: 
(b) Waveform 2
Reference: 
(c) Waveform 3
Reference: 
(d) Waveform 4
Reference: 
(e) Waveform 5
Reference: 
(f) Waveform 6
Reference: 
(g) Waveform 7
Reference:
(h) Waveform 8
Reference: 
Problem symptoms table
HINT:
If a normal code is displayed during the diagnostic trouble
code check although the trouble still occurs, check the
electrical circuits for each symptom in the order given in
the chart ...
Diagnosis system
1. DESCRIPTION
(a) When troubleshooting OBD II vehicles, the only
difference from the usual troubleshooting procedure
is to connect an OBD II scan tool complying with
SAE J1987 or a intelligen ...
Other materials:
Removal
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to
prevent the airbag working.
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEE ...
ACC Power Source Circuit
DESCRIPTION
This circuit supplies power to the A/C amplifier and the illumination for the
clock.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT FUSE (ECU ACC)
(a) Remove the ECU ACC fuse from the engine room relay
block.
(b) Measure the resistance according to the value(s) in the
tab ...
Definition of terms
Terms
Definitions
Monitor Description
Description of what ECM monitors and how to detect malfunctions
(monitoring purpose and details).
Related DTCs
A group of diagnostic trouble codes that are output by ECM based on
the same malfunction detection lo ...
