Toyota Sienna Service Manual: Terminals of ecu

Parts location

HOW TO PROCEED WITH TROUBLESHOOTING 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS (a) Confirm problem symptoms. 3 CHECK AND CLEAR DTCS 4 PROBLEM SYMPTOM CONFIRMATIO ...

Diagnosis system

1. CHECK DLC3 (a) The vehicle's ECM uses the ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format. HINT: Connect the ...

Other materials:

Repair
1. INTRODUCTION (a) This section introduces ways to determine whether the run-flat tire is repairable or not. Repair must be performed by following the appropriate procedures. If a flat tire occurs, it is possible to drive a maximum of 160 km (100 miles) at a speed below 90 km/h (55 mph) due ...

Installation
1. INSTALL BRAKE ACTUATOR (a) Install the brake actuator assembly with the 2 nuts. Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 2. INSTALL BRAKE ACTUATOR WITH BRACKET (a) Install the actuator with bracket with the 3 bolts. Torque: 20 N*m (199 kgf*cm, 14 ft.*lbf) NOTICE: Be careful not to dam ...

Speedometer Malfunction
DESCRIPTION Factors that affect the indicated vehicle speed include tire size, tire inflation, and tire wear. The speed indicated on the speedometer has an allowable margin of error. This can be tested using a speedometer tester (calibrated chassis dynamometer). For details about testing and ...