Toyota Sienna Service Manual: Terminals of ECU
1. RADIO AND NAVIGATION ASSEMBLY
*1: with Rear Seat Entertainment System
- Reference: waveform 1
HINT:
- Terminal: VV+ - VV-
- Gauge set: 200 mV/DIV, 10 μs/DIV
- Condition: DVD is played on radio and navigation assembly
- Reference: waveform 2
HINT:
- Terminal: V+ - CGND
- Gauge set: 0.2 V/DIV, 0.2μs/DIV
- Condition: Ignition switch: ON, shift lever: R position
2. STEREO COMPONENT AMPLIFIER
3. TELEVISION DISPLAY ASSEMBLY
Problem symptoms table
HINT:
Before inspecting the suspected areas listed in the table
below, check the fuse and relay.
Before inspecting the suspected areas listed in the table
below, check the DTCs.
...
DTC check / clear
HINT:
Illustrations may differ from the actual vehicle depending
on the device settings and options. Therefore, some
detailed areas may not be shown exactly the same as on
the actual v ...
Other materials:
Diagnosis system
1. CHECK DLC3
(a) The vehicle's ECM uses the ISO 15765-4 for
communication. The terminal arrangement of the
DLC3 complies with SAE J1962 and matches the
ISO 15765-4 format.
HINT:
Connect the cable of the intelligent tester to the
DLC3, turn the ignition switch to the ON position
and atte ...
Rear window wiper and
washer
Operating the wiper lever
Turning the end of the lever turns on the rear window wiper and
washer.
The illustration is intended as an example.
*1 or
*2
Intermittent window
wiper operation
*1 or
*2
Normal window wiper
operation
Washer/wiper dual operation
Washer/wiper du ...
On-vehicle inspection
1. INSPECT THROTTLE BODY
Listen to the throttle control motor operating sounds.
Turn the ignition switch to the ON position.
When pressing the accelerator pedal position
sensor lever, listen to the running motor. Make
sure that no friction noise comes from the
motor.
...
