Toyota Sienna Service Manual: Terminals of ECU
1. CHECK OUTER MIRROR CONTROL ECU LH
- Disconnect the O9 and O10 connectors.
- Measure the voltage and resistance according to the value(s) in the table below.
Voltage
Resistance
If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the O9 and O10 connectors.
- Measure the voltage according to the value(s) in the table below
Voltage
If the result is not as specified, there may be a malfunction on the ECU side.
2. CHECK OUTER MIRROR CONTROL ECU RH
- Disconnect the O11 and O12 connectors.
- Measure the voltage and resistance according to the value(s) in the table below.
Voltage
Resistance
If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the O11 and O12 connectors.
- Measure the voltage according to the value(s) in the table below.
Voltage
If the result is not as specified, there may be a malfunction on the ECU side.
Problem symptoms table
HINT:
Use the table below to help determine the cause of the
problem symptoms. The potential causes of the symptoms
are listed in order of probability in the ''Suspected Area''
column ...
Diagnosis system
1. DESCRIPTION
When troubleshooting a vehicle with the diagnosis
system, the only difference from the usual
troubleshooting procedure is connecting the
intelligent tester to the vehicl ...
Other materials:
Rear evaporator temperature sensor circuit
DESCRIPTION
The rear evaporator temperature sensor is installed on the rear evaporator.
It detects the rear evaporator
temperature. The sensor sends a signal to the A/C amplifier. The resistance of
the rear evaporator
temperature sensor changes in accordance with the rear evaporator temperatu ...
Vehicle Position Mark is not Updated
INSPECTION PROCEDURE
1 CHECK MAP DISC
Check that the map disc is not deformed or cracked.
OK:
No deformations or cracks on map disc.
2 CHECK MAP DISPLAY
Check if a touch scroll can be performed on the map
display.
OK:
Touch scroll can be performed
3 CHECK VEHICLE SENSOR (NAV ...
Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2. REMOVE V-BANK COVER SUB-ASSEMBLY (See
page EM-28)
3. REMOVE PURGE VSV
(a) Disconnect the purge VSV connector.
(b) Disconnect the 2 purge line hoses from the purge
VSV.
(c) Remove the purge VSV from the air cleaner hose.
(d) R ...
