Toyota Sienna Service Manual: Terminals of ECU
1. POSITION CONTROL ECU AND SWITCH ASSEMBLY (POWER SEAT CONTROL SWITCH AND ECU)
- Disconnect the P58 and P59 connectors.
- Check the voltage of each terminal of the wire harness side connectors.
If the result is not as specified, there may be a malfunction in the wire harness side.
- Check the resistance of each terminal of the wire harness side connectors.
If the result is not as specified, there may be a malfunction in the wire harness side.
- Reconnect the P58 and P59 connectors.
- Check the voltage of each terminal of the connectors.
If the result is not as specified, the position control ECU and switch assembly may be malfunctioning.
2. OUTER MIRROR CONTROL ECU LH
- Disconnect the outer mirror control ECU LH connector.
- Check the voltage of each terminal of the wire harness side connectors.
If the result is not as specified, there may be a malfunction in the wire harness side.
- Check the resistance of each terminal of the wire harness side connector.
If the result is not as specified, there may be a malfunction in the wire harness side.
- Reconnect the outer mirror control ECU LH connector.
- Check the voltage of each terminal of the connectors.
If the result is not as specified, the outer mirror control ECU LH may be malfunctioning.
Problem symptoms table
HINT:
Inspect the fuse and relay before confirming the suspected
areas in the table below.
Inspect each suspected area in numerical order for the
corresponding symptom.
If the ...
Diagnosis system
1. DESCRIPTION
Front power seat control system data can be read
through the Data Link Connector 3 (DLC3) of the
vehicle. When the system seems to be
malfunctioning, use the intelligent ...
Other materials:
Distance Control ECU Power Source Circuit
DESCRIPTION
This circuit provides power to operate the distance control ECU. The distance
control ECU determines
information about the vehicle in front based on data from the laser sensor, and
then decides how much
acceleration and/or deceleration is needed to maintain the set distance. The
...
Inspection
1. INSPECT SPEED SENSOR (NT SENSOR)
(a) Disconnect the speed sensor connector from the
transaxle.
(b) Measure the resistance according to the value(s) in
the table below.
AISIN made:
TOYOTA made:
2. INSPECT SPEED SENSOR (NC SENSOR)
(a) Disconnect the speed sensor connector from ...
Customize parameters
HINT:
The following items can be customized.
NOTICE:
After confirming whether the items requested by the
customer are applicable or not for customization,
perform the customize operation.
Be sure to record the current settings before
customizing.
When troubleshootin ...
