1. CHECK POWER SLIDE DOOR ECU LH
If the result is not as specified, there may be a malfunction on the wire harness side.
*1 Satellite switch (Slide door LH)
*2 Power slide door control switch LH
*3 Transmitter switch (Slide door LH)
*4 When all the conditions listed below are met, the
warning buzzer sounds.
*5 When any condition listed below is met, the sounding warning buzzer stops.
*6 Terminal SEL is used for distinction between the power slide door ECU LH and RH. Only terminal SEL of the power slide door ECU LH is grounded.
HINT: Use an oscilloscope to check the output voltages of the power slide door main switch, buzzer and pulse sensor.
If the result is not as specified, the ECU may have a malfunction.
2. CHECK POWER SLIDE DOOR ECU RH
If the result is not as specified, there may be a malfunction on the wire harness side.
*1 Satellite switch (Slide door RH)
*2 Power slide door control switch RH
*3 Transmitter switch (Slide door RH)
*4 When all the conditions listed below are met, the
warning buzzer sounds.
*5 When any condition listed below is met, the sounding warning buzzer stops.
HINT: Use an oscilloscope to check the output voltages of the power slide door main switch, buzzer and pulse sensor.
If the result is not as specified, the ECU may have a malfunction.
Installation
1. INSTALL TIRE PRESSURE WARNING RESET SWITCH
(a) Engage the 2 claws to install the tire pressure
warning reset switch to the lower instrument panel
finish panel sub-assembly LH.
2. INSTALL LOWER INSTRUMENT PANEL FINISH
PANEL SUB-ASSEMBLY LH
3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
4. IN ...
Steering Angle Sensor Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Steering Angle Sensor
Communication Stop
Mode
"Steering angle sensor" is not displayed on the
"Communication Bus Check" screen of the
intelligent tester
Applies to &qu ...
Terminals of ecu
1. A/C AMPLIFIER
HINT:
Check from the rear of the connector while it is
connected to the A/C amplifier.
(a) Waveform 1:
(b) Waveform 2: ...