Toyota Sienna Service Manual: Terminals of ECU
1. CHECK POWER SLIDE DOOR ECU LH (WITH POWER SLIDE DOOR)
- Disconnect the P25 and P26 ECU connectors, and check the voltage and resistance of each terminal of the wire harness side connectors.
If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the ECU connectors, and check the voltage of each terminal of the connectors.
If the result is not as specified, the ECU may have a malfunction.
2. CHECK POWER SLIDE DOOR ECU RH
- Disconnect the P27 and P28 ECU connectors, and check the voltage and resistance of each terminal of the wire harness side connectors.
If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the ECU connectors, and check the voltage of each terminal of the connectors.
If the result is not as specified, the ECU may have a malfunction.
3. CHECK SLIDE DOOR CLOSER RELAY LH (WITHOUT POWER SLIDE DOOR)
- Disconnect the S37 relay connector, and check the voltage and resistance of each terminal of the wire harness side connectors.
If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the relay connector, and check the voltage of each terminal of the connectors.
If the result is not as specified, the relay may have a malfunction.
Problem symptoms table
SLIDE DOOR CLOSER SYSTEM
Symptom
Suspected Area
Slide door closer LH does not operate (*1)
ECU-B fuse
Power slide door lock assembly LH
Power slide do ...
Diagnosis system
1. CHECK DLC3
The vehicle's ECU uses ISO 15765-4 for
communication protocol. The terminal arrangement
of the DLC3 complies with SAE J1962 and matches
the ISO 15765-4 format.
NOT ...
Other materials:
Reassembly
1. INSTALL REAR DOOR WIRE SUB-ASSEMBLY LH
Install the wire.
NOTICE:
When installing the wire, push the areas where
the clips are installed in order to prevent
damage and deformation.
Install the 2 screws.
2. INSTALL REAR DOOR LOCK ASSEMBLY LH
Apply MP grease to the slidi ...
Installation
1. INSTALL REAR DOOR GLASS WEATHERSTRIP
Install the rear door glass weatherstrip.
2. INSTALL SLIDE DOOR WINDOW ASSEMBLY
3. INSTALL REAR DOOR GLASS RUN
4. INSTALL REAR DOOR TRIM BOARD SUBASSEMBLY
5. INSTALL SIDE TRIM BOARD COVER REAR
6. INSTALL REAR DOOR WINDOW FRAME SUBASSEMBLY
7. INSTA ...
Reassembly
1. INSTALL UNDERDRIVE PLANETARY RING GEAR
HINT:
Use a torque wrench with a fulcrum length of 160
mm (6.3 in.).
(a) Install a new snap ring to the outer race of the radial
ball bearing rear.
HINT:
When replacing the bearing, also replace the
counter driven gear with a new one.
(b) Us ...
