Toyota Sienna Service Manual: Terminals of ECU
1. CHECK POWER BACK DOOR ECU
- Disconnect the P13 and P14 ECU connectors, and check the voltage and resistance of each terminal of the wire harness side connectors
If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the ECU connectors, and check the voltage of each terminal of the connectors
If the result is not as specified, the ECU may have a malfunction.
Initialization
1. RESET
When the battery is reconnected:
The back door is locked and therefore cannot be
opened. Therefore, it is necessary to unlock the
back door using the door control switch or
...
Diagnosis system
1. CHECK DLC3
The vehicle's ECU uses ISO 15765-4 for
communication protocol. The terminal arrangement
of the DLC3 complies with SAE J1962 and matches
the ISO 15765-4 format.
NOT ...
Other materials:
Power Back Door Warning Buzzer does not Sound
DESCRIPTION
The power back door system uses a warning buzzer built into the
back door, which has 3 ways of
sounding that are used differently according to the situations:
When all the following conditions are met, the warning buzzer sounds at
a cycle of 0.3 seconds:
* The ignitio ...
Data list / active test
HINT:
By accessing the DATA LIST displayed by the intelligent
tester, you can perform such functions as reading the values
of switches and sensors without removing any parts. Reading
the DATA LIST as the first step in troubleshooting is one
method to shorten labor time.
1. DATA LIST FOR OCCUPA ...
Changing engine switch modes
Modes can be changed by pressing the engine switch with the brake
pedal released. (The mode changes each time the switch is pressed.)
Off*
Emergency flashers can be used.
ACCESSORY mode
Some electrical components such
as the audio system can be used.
The engine switch indicator tu ...
