1. CHECK POWER BACK DOOR ECU
If the result is not as specified, there may be a malfunction on the wire harness side.
*1 Satellite switch (Back door)
*2 Transmitter switch (Back door)
*3 When all the conditions listed below are met, the
warning buzzer sounds.
*4 When any condition listed below is met, the warning buzzer turns off.
HINT: Use an oscilloscope to check the output voltages of the power back door main switch, buzzer and pulse sensor.
If the result is not as specified, the ECU may have a malfunction.
Installation
1. INSTALL 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
Check the degree of tilt when the belt begins to lock
the ELR.
Check that the belt does not lock within 15 of
tilt in all directions but that the belt locks with
over 45 of tilt, when gently moving the
retractor.
If ...
Terminals of ECU
1. FOLD SEAT CONTROL ECU LH
Disconnect the fold seat control ECU connectors.
Measure the voltage and resistance of the wire
harness side connectors.
If the result is not as specified, there may be a
malfunction on the wire harness side.
Reconnect the fold seat control E ...
AVC-LAN Circuit
DESCRIPTION
Each unit of the audio system connected to the AVC-LAN (communication bus)
transfers the signal of
each switch by communication.
When a short to +B or short to ground occurs in this AVC-LAN, the audio system
will not function normally
as the communication is discontinued.
INSP ...