Toyota RAV4 manuals

Toyota Sienna Service Manual: Test mode procedure

Perform zero point calibration of yaw rate and deceleration sensor (when using sst check wire)
NOTICE: While obtaining the zero point, do not vibrate the vehicle by tilting, moving or shaking it and keep it in a stationary condition. (Do not turn the ignition switch to the ON position ...

Warning light and indicator light bulb check
(a) Check the warning lights. (1) Release parking brake pedal. (2) When the ignition switch is turned to the ON position, check that the ABS warning light, BRAKE warning light, VSC warning ...

Other materials:

Access monitor result
(A) select the following menus on the intelligent tester: diagnosis, enhanced obdii, monitor info and monitor result. The monitor status appears after the component name. INCMP: The component has not been monitored yet. PASS: The component is functioning normally. FAIL: The component is ...

Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The stereo jack adapter sends an external device sound signal to the radio receiver through this circuit. The sound signal that has been sent is amplified by the stereo component amplifier or radio receiver, and then is sent to the speakers. If there is an open or short in th ...

Terminals of ecu
1. Terminal of ECU (*1): Models with dynamic laser cruise control (*2): 2WD model 2. Terminal Inspection (a) Disconnect the connector and measure the voltage or resistance on the wire harness side. HINT: Voltage cannot be measured with the connector connected to the skid control ECU ...

В© 2011-2024 Copyright www.tsienna.net