Toyota Sienna Service Manual: Theft deterrent
- Theft deterrent system
- System description
- How to proceed with troubleshooting
- Customize parameters
- Problem symptoms table
- Terminals of ECU
- Engine hood courtesy switch
- Security horn assembly
Installation
1. INSTALL 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
Check the degree of tilt when the belt begins to lock
the ELR.
Check that the belt does not lock within 15 of
tilt in all ...
Theft deterrent system
PARTS LOCATION
...
Other materials:
Initialization
HINT:
The seatback position is initialized at the factory before
shipment, so initialization is not normally required.
There is an initialization function for cases when
reinitialization is required.
Before performing initialization procedure and initialization
release step ...
Intermediate Shaft Speed Sensor "A"
DESCRIPTION
This sensor detects the rotation speed of the counter gear. By comparing the
counter gear speed signal
(NC) with the direct clutch speed sensor signal (NT), the ECM detects the shift
timing of the gears and
appropriately controls the engine torque and hydraulic pressure according ...
Disassembly
1. REMOVE SIDE DEFROSTER NOZZLE DUCT NO.1
(a) Remove the 2 screws <C> and defroster nozzle
duct No. 1.
2. REMOVE SIDE DEFROSTER NOZZLE DUCT NO.2
(a) Remove the 2 screws <C> and defroster nozzle
duct No. 2.
3. REMOVE DEFROSTER NOZZLE ASSEMBLY
(a) Remove the 4 screws <C> and d ...
