Toyota Sienna Service Manual: Thermostat

Installation

1. INSTALL WATER PUMP ASSEMBLY (a) Install a new water pump gasket and the water pump assembly with the 16 bolts. Torque: Bolt A 21 N*m (214 kgf*cm, 15 ft.*lbf) Bolts B and C 9.1 N*m (93 kgf ...

Removal

1. REMOVE V-BANK COVER SUB-ASSEMBLY (See page EM-28) 2. REMOVE NO. 1 ENGINE UNDER COVER (See page EM-26) 3. DRAIN ENGINE COOLANT (See page CO-6) 4. REMOVE FRONT WHEEL RH 5. REMOVE FRONT FENDER A ...

Other materials:

Data list / active test
1. DATA LIST HINT: Using the intelligent tester to read the DATA LIST allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered ...

Crankshaft Position Sensor
DESCRIPTION The Crankshaft Position (CKP) sensor system consists of a CKP sensor plate and a pickup coil. The sensor plate has 34 teeth and is installed on the crankshaft. The pickup coil is made of an iron core and a magnet. The sensor plate rotates as each tooth passes through the pi ...

Disposal
HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side.  When scrapping a vehicle equipped with the SRS or disposing of the front seat side airbag assembly, be sure to deploy the airbag first in accordance with the proc ...